Assembler:Commands:CMOVNZ
command cmovnz destination, source
cmovnz is CMOVcc instruction, The cmovnz conditional move if not zero check the state of ZF.
If ZF=0 then condition is satisfied, otherwise it will be skipped.
CMOVcc instructions are mainly used after CMP
The CMOVcc instructions check the state of one or more of the status flags in the EFLAGS register (CF, OF, PF, SF, and ZF) and perform a move operation if the flags are in a specified state (or condition). A condition code (cc) is associated with each instruction to indicate the condition being tested for. If the condition is not satisfied, a move is not performed and execution continues with the instruction following the CMOVcc instruction.
These instructions can move a 16- or 32-bit value from memory to a general-purpose register or from one general-purpose register to another. Conditional moves of 8-bit register operands are not supported.
The terms "less" and "greater" are used for comparisons of signed integers and the terms "above" and "below" are used for unsigned integers.
Command Parameters[edit]
| Parameter | Description |
|---|---|
| destination | r16 / r32 |
| source | m16-r16 / m32-r32 |
Examples[edit]
cmovnz dx,ax
cmovnz cx,[bx]
cmovnz edx,[edx+110]
cmovnz eax,edx
cmovnz esi,[00123abc]
cmovnz edi,[UserDefinedSymbol]
