Assembler:Commands:CMOVNO
command cmovno destination, source
cmovno is CMOVcc instruction, The cmovno conditional move if not overflow check the state of OF.
If OF=0 then condition is satisfied, otherwise it will be skipped.
CMOVcc instructions are mainly used after CMP
The CMOVcc instructions check the state of one or more of the status flags in the EFLAGS register (CF, OF, PF, SF, and ZF) and perform a move operation if the flags are in a specified state (or condition). A condition code (cc) is associated with each instruction to indicate the condition being tested for. If the condition is not satisfied, a move is not performed and execution continues with the instruction following the CMOVcc instruction.
These instructions can move a 16- or 32-bit value from memory to a general-purpose register or from one general-purpose register to another. Conditional moves of 8-bit register operands are not supported.
The terms "less" and "greater" are used for comparisons of signed integers and the terms "above" and "below" are used for unsigned integers.
cmovno is CMOVcc instruction, The cmovno (conditional move if not overflow) check the state of OF, if OF=0 then condition satisfied and the cmovno will be executed. Otherwise it will be skipped, and the execution will continues with the instruction following it. cmovno is used for signed integers.
Command Parameters
| Parameter | Description |
|---|---|
| destination | r16 / r32 |
| source | m16-r16 / m32-r32 |
Examples
cmovno dx,ax
cmovno cx,[bx]
cmovno edx,[edx+110]
cmovno eax,edx
cmovno esi,[00123abc]
cmovno edi,[UserDefinedSymbol]
