Assembler:Commands:CMOVNB
command cmovnb destination, source
cmovnb is CMOVcc instruction, The cmovnb conditional move if not below check the state of CF.
If CF=0 then condition is satisfied, otherwise it will be skipped.
CMOVcc instructions are mainly used after CMP
The CMOVcc instructions check the state of one or more of the status flags in the EFLAGS register (CF, OF, PF, SF, and ZF) and perform a move operation if the flags are in a specified state (or condition). A condition code (cc) is associated with each instruction to indicate the condition being tested for. If the condition is not satisfied, a move is not performed and execution continues with the instruction following the CMOVcc instruction.
These instructions can move a 16- or 32-bit value from memory to a general-purpose register or from one general-purpose register to another. Conditional moves of 8-bit register operands are not supported.
The terms "less" and "greater" are used for comparisons of signed integers and the terms "above" and "below" are used for unsigned integers.
Command Parameters
| Parameter | Description |
|---|---|
| destination | r16 / r32 |
| source | m16-r16 / m32-r32 |
Examples
cmovnb dx,ax
cmovnb cx,[bx]
cmovnb edx,[edx+110]
cmovnb eax,edx
cmovnb esi,[00123abc]
cmovnb edi,[UserDefinedSymbol]
