Difference between revisions of "Assembler:Commands:PUSHA"
Jump to navigation
Jump to search
| (One intermediate revision by the same user not shown) | |||
| Line 9: | Line 9: | ||
Note: Not available in 64 bit mode. | Note: Not available in 64 bit mode. | ||
| − | |||
| − | |||
| − | |||
| − | + | {{AssemblerCommandParametersNone}} | |
| − | |||
| − | |||
== Examples == | == Examples == | ||
pusha | pusha | ||
| − | + | {{AssemblerCommandSeeAlso}} | |
| − | |||
| − | |||
| − | |||
| − | + | {{Template:AssemblerCommandExternalLinks}} | |
| − | |||
| − | |||
| − | |||
| − | |||
| − | |||
Latest revision as of 15:32, 3 January 2018
command pusha
This instruction PUSHes all the general purpose registers onto the stack in the following order: AX, CX, DX, BX, SP, BP, SI, DI. The value of SP pushed is the value before the instruction is executed. It is useful for saving state before an operation that could potential change these registers.
Note: Not available in 64 bit mode.
Command Parameters[edit]
<none>
Examples[edit]
pusha
