TheyCallMeTim13: Created page with 'Category:Assembler '''command''' hlt Halt. Places the processor in a HALT state.
Stops instru…'

2018-01-22T22:26:22Z

Created page with 'Category:Assembler '''command''' hlt Halt. Places the processor in a HALT state. <div style="padding:2px;border:1px dashed #2f6fab;background-color:#f4f4f4;"> Stops instru…'

New page

[[Category:Assembler]]
'''command''' hlt

Halt. Places the processor in a HALT state.

<div style="padding:2px;border:1px dashed #2f6fab;background-color:#f4f4f4;">
Stops instruction execution and places the processor in a HALT state. An enabled interrupt (including NMI and SMI), a debug exception, the BINIT# signal, the INIT# signal, or the RESET# signal will resume execution. If an interrupt (including NMI) is used to resume execution after a HLT instruction, the saved instruction pointer (CS:EIP) points to the instruction following the HLT instruction.

When a HLT instruction is executed on an IA-32 processor supporting Hyper-Threading Technology, only the logical processor that executes the instruction is halted. The other logical processors in the physical processor remain active, unless they are each individually halted by executing a HLT instruction.

The HLT instruction is a privileged instruction. When the processor is running in protected or virtual-8086 mode, the privilege level of a program or procedure must be 0 to execute the HLT instruction.

[http://c9x.me/x86/html/file_module_x86_id_134.html c9x.me/x86/html/file_module_x86_id_134.html]
</div>

{{AssemblerCommandParametersNone}}

{{AssemblerCommandSeeAlso}}

{{Template:AssemblerCommandExternalLinks}}

Assembler:Commands:HLT - Revision history

TheyCallMeTim13: Created page with 'Category:Assembler '''command''' hlt Halt. Places the processor in a HALT state. Stops instru…'

TheyCallMeTim13: Created page with 'Category:Assembler '''command''' hlt Halt. Places the processor in a HALT state.
Stops instru…'